JOB: Electrical Engineer At General Electric In Bengaluru

- Advertisement -

APPLY HERE

Location: Bengaluru

Company: General Electric

As an Electrical Engineer within our Maternal and Infant Care (MIC) hardware team, you will be instrumental in developing new products and supporting our existing Maternal and Fetal care products. Your role will encompass end-to-end electronic hardware design and firmware development for PWA (Printed Wiring Assembly) boards. You will thrive in a fast-paced environment, collaborating with a dynamic team to deliver high-quality results.

Key Responsibilities

• Circuit Design: Develop electronic circuits and interconnects involving Digital, Analog, Power, and microcontroller/microprocessor-based designs.
• Sensor Interface: Design low-voltage and low-noise front end circuit for the sensor interfaces such as ultrasound crystals, ECG, and temperature sensors.
• Simulation and Analysis: Conduct circuit simulations using pSpice and perform design calculations for active filters, switched-mode power supplies, and derating analysis.
• Firmware Development: Create and implement embedded software for device drivers and communication interfaces using RTOS and 32-bit controllers.
• Product Development: Engage in the complete product development lifecycle, including concept, architecture, prototyping, documentation, testing, supply chain management, manufacturing, and service support.
• Documentation: Prepare and maintain comprehensive hardware design documentation (HDD), design verification plans (DVP), FMEAs (Failure Modes and Effects Analysis), and formal board-level verification reports.
• Troubleshooting: Address board bring-up challenges and oversee design verification and validation processes.

Required Qualifications

• Bachelor’s or Master’s degree in Electronics and Communication Engineering.
• Minimum of 3 years of experience in electronics and firmware development.

Desired Skills and Experience

• Proficiency in Digital, Analog, Power, and microcontroller/microprocessor-based designs.
• Hands-on experience with C/C++ programming for microcontrollers and DSPs.
• Expertise in real-time operating systems (RTOS) and efficient CPU utilization.
• Extensive experience in the end-to-end electronic hardware design and development process.
• Troubleshooting knowledge in the board bring-up using oscilloscope, Function generator, Spectrum analysis and data logger.
• Familiarity with design simulation tools like pSpice or LTspice.
• Experience collaborating with ECAD engineering teams on PCB layout design.
• Strong teamwork, coordination, and communication skills.
• Ability to meet rigorous targets for reliability, performance, cost, serviceability, and delivery.
• Effective oral and written communication skills.
• Experience with global projects is a plus.

Quality Specific Goals

• Adhere to GE Healthcare’s Quality Management System, Quality Management Policy, Quality Goals, and relevant laws and regulations.
• Identify and report any quality or compliance issues, taking immediate corrective action as necessary.